ATM Forum Message | |
| Forums: |
Atm ·
Astrophotography ·
Blackholes ·
Blackholes2 ·
CCD ·
Celestron ·
Domes ·
Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem |
|
|
|
|
||||
|
|
||||||
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place... The Space and Astronomy Agora |
| Re: Re: Our Grinding Machine
Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To Posted by Mike O'Connor on November 6, 2000 02:22:17 UTC |
I don't have them at hand, but I will check them closer later in the week, they are at my farmhouse. 2 of the 1/4 hp motors came from old sump-pumps. The other 3 motors came from washers and dryers. We also looked pretty hard for some discarded 1" steel for spindles, but we decided that we should purchase these new..along with new berrings and belts. This will be a very slow project. I have a garage sized building to house it, so table size is not an issue. All options are open..and I rather like the full length driven-arm idea. |
|
| Additional Information |
|---|
 |
| About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
|
Unless otherwise specified, web site content Copyright 1994-2025 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |