Back to Home

General Forum Message

Forums: Atm · Astrophotography · Blackholes · Blackholes2 · CCD · Celestron · Domes · Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem
RSS Button

Home | Discussion Forums | Misc. Topics | Post

Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place...
The Space and Astronomy Agora
Starfinder 10-inch - Rings

Forum List | Follow Ups | Post Message | Back to Thread Topics
Posted by Bob Bennett on September 20, 2000 14:32:04 UTC

I accidentally posted this questin to the eyepiece - hope i have it right this time.

I have a 10-inch Meade Starfinder which is awkward to use - problem is that when I first set it up for a viewing session, I have to rotate the OTA such that both my shorty little wife and myself can see through the finder and eyepiece. If i then point the telescope to a different part of the sky I have to undo the rings then rotate the OTA
again to reposition the finder and eyepiece. Not only is this cumbersome - I also risk dropping the OTA on the ground.

Does anyone know of an aftermarket ring system which allow you to rotate the OTA without undoing the rings?

thanks for any help

Follow Ups:

Post A Message



Follow Ups:

Login to Post
Additional Information
About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy
Unless otherwise specified, web site content Copyright 1994-2023 John Huggins All Rights Reserved
Forum posts are Copyright their authors as specified in the heading above the post.
"dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET"
are trademarks of John Huggins