ATM Forum Message | |
| Forums: |
Atm ·
Astrophotography ·
Blackholes ·
Blackholes2 ·
CCD ·
Celestron ·
Domes ·
Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem |
|
|
|
|
||||
|
|
||||||
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place... The Space and Astronomy Agora |
| Made Pitch Lap
Forum List | Follow Ups | Post Message | Back to Thread Topics Posted by Rick on November 29, 2001 16:37:29 UTC |
Well i went ahead and made the pitch lap,but i guess i waited to long before pouring, instead of having a full size lap, mine ended up at 9-1/4". thats not to bad, but it is off center.(1/4" on one side, and 1/2" on the other) got it all pressed out after afew hours work, is mated great right now,even pressed the micro mesh pattern on it on the last press.now i was thinking if i drew a circle on the top of the tool,(where the pitch really is)so i would know where it was when on top, things should be ok...what do you all think, will this work or should i stick to mirror on top?
|
|
| Additional Information |
|---|
 |
| About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
|
Unless otherwise specified, web site content Copyright 1994-2025 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |