Back to Home

ATM Forum Message

Forums: Atm · Astrophotography · Blackholes · Blackholes2 · CCD · Celestron · Domes · Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem
RSS Button
Home | Discussion Forums | Amateur Telescope Making | Post
Login
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place...
The Space and Astronomy Agora
Re: Re: Well Al Tell Us How...

Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To
Posted by Rick Crockett on February 9, 2001 04:21:43 UTC

Al:

I want to thank you for your input. I did see a test where most of the coatings were close but under thier claims. The highest measured reflectance was 95% but still I consider that good.

Now the machine that takes all that power, is that the one limited to 8"? If so I suppose it takes up a lot of room doing multiple fixturing and multiple coatings in one pulldown?

An old Varian I am trying to resurect had 220v 15amp for the pumps and motors and 220v 35amp for the tunsten boat.

I hear silver is difficult do vacuum deposit. What extra effort do you have for that?

-Rick

Follow Ups:

Login to Post
Additional Information
Google
 
Web www.astronomy.net
DayNightLine
About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy
Unless otherwise specified, web site content Copyright 1994-2024 John Huggins All Rights Reserved
Forum posts are Copyright their authors as specified in the heading above the post.
"dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET"
are trademarks of John Huggins