ATM Forum Message | |
| Forums: |
Atm ·
Astrophotography ·
Blackholes ·
Blackholes2 ·
CCD ·
Celestron ·
Domes ·
Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem |
|
|
|
|
||||
|
|
||||||
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place... The Space and Astronomy Agora |
| Gear Cutting
Forum List | Follow Ups | Post Message | Back to Thread Topics Posted by Henry/">Henry on December 16, 1998 00:06:04 UTC |
I have recently hobbed a gear using a 7/16-14 tap hoping for 240 teeth on a 5.460" dia. wheel. Unfortunately, the cut produced 244 teeth. Does anyone know the proper formula to use to find the correct outside dimension of the wheel? Any help will be greatly appreciated. |
|
| Additional Information |
|---|
 |
| About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
|
Unless otherwise specified, web site content Copyright 1994-2025 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |