Back to Home

ATM Forum Message

Forums: Atm · Astrophotography · Blackholes · Blackholes2 · CCD · Celestron · Domes · Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem
RSS Button

Home | Discussion Forums | Amateur Telescope Making | Post
Login

Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place...
The Space and Astronomy Agora
Huh?

Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To
Posted by Rick Crockett on April 18, 2007 04:53:15 UTC

I am guessing I understand what you are saying.

The question is why there is astigmatism... Assuming you rotate lense and direction of stroke with regards to the tool then wedge in the tool should not matter. It is important that the tool does not flex because of an uneven work surface. Also the mirror is too thin to block. If you do block it then only with a small backing as the glass could be drawn into astigmatism.

The anneal could also be bad but if the problem orginated with an uneven blank then it should grind out fine. Working around a barrel I would:
push push push rotate work cw to the right push push push step cw to the left and repeat. This way the tool/lense rotated about twice + for each trip around the barrel.
-Rick

Follow Ups:

Login to Post
Additional Information
Google
 
Web www.astronomy.net
DayNightLine
About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy
Unless otherwise specified, web site content Copyright 1994-2024 John Huggins All Rights Reserved
Forum posts are Copyright their authors as specified in the heading above the post.
"dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET"
are trademarks of John Huggins