ATM Forum Message | |
| Forums: |
Atm ·
Astrophotography ·
Blackholes ·
Blackholes2 ·
CCD ·
Celestron ·
Domes ·
Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem |
|
|
|
|
||||
|
|
||||||
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place... The Space and Astronomy Agora |
| Re: Cutting Formica?
Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To Posted by Robert May on October 30, 1998 11:50:09 UTC |
: Is there a trick or tip to cutting Formica accurately without chipping it? The way that I know about is using a router with a small bit. This is how the stuff is cut (very carefully at that) to make tops, etc. Also note that it is backed up with something stiff. You may want to use some double sided tape to hold it down before doing the routing. Good Luck. Bob May
|
|
| Additional Information |
|---|
 |
| About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
|
Unless otherwise specified, web site content Copyright 1994-2024 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |