Back to Home

ATM Forum Message

Forums: Atm · Astrophotography · Blackholes · Blackholes2 · CCD · Celestron · Domes · Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem
RSS Button

Home | Discussion Forums | Amateur Telescope Making | Post
Login

Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place...
The Space and Astronomy Agora
Re: Cutting Formica?

Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To
Posted by Robert May on October 30, 1998 11:50:09 UTC

: Is there a trick or tip to cutting Formica accurately without chipping it? The way that I know about is using a router with a small bit. This is how the stuff is cut (very carefully at that) to make tops, etc. Also note that it is backed up with something stiff. You may want to use some double sided tape to hold it down before doing the routing. Good Luck. Bob May

Follow Ups:

Login to Post
Additional Information
Google
 
Web www.astronomy.net
DayNightLine
About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy
Unless otherwise specified, web site content Copyright 1994-2020 John Huggins All Rights Reserved
Forum posts are Copyright their authors as specified in the heading above the post.
"dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET"
are trademarks of John Huggins