ATM Forum Message | |
| Forums: |
Atm ·
Astrophotography ·
Blackholes ·
Blackholes2 ·
CCD ·
Celestron ·
Domes ·
Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem |
|
|
|
|
||||
|
|
||||||
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place... The Space and Astronomy Agora |
| You Were Right
Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To Posted by Thomas Picciani on January 11, 2003 03:15:30 UTC |
I started using the minitool again and it began to work once I figured out how to use it. I found that keeping my index finger on the center of it and gently sliding it around worked best. I tried 2 trips and took a look at the ronchi. There was a tiny bit of movement to the good. I eventually did 8 trips and I'm pretty close. Maybe a little high. The lines show a high 70% zone and a hole. My last measurement agreed. I'm going to smooth the edge with a little bit of MOT 1 inch stroke. That should bring the center up and smooth out things too.
|
|
|
| Additional Information |
|---|
 |
| About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
|
Unless otherwise specified, web site content Copyright 1994-2024 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |