|
|
|||||
|
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place... The Space and Astronomy Agora |
Thanks Again Bob!
Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To Posted by Greg Tedford on August 19, 2002 22:33:45 UTC |
I'll change the teeth to a backwards drag instead of a cut as per your advice. I have managed to slow the headstock down to about 150 rpm and i will make some sort of well around the glass to keep the grit\water mix near the cutter.
|
|
Additional Information |
---|
About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
Unless otherwise specified, web site content Copyright 1994-2024 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |