ATM Forum Message | |
| Forums: |
Atm ·
Astrophotography ·
Blackholes ·
Blackholes2 ·
CCD ·
Celestron ·
Domes ·
Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem |
|
|
|
|
||||
|
|
||||||
Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place... The Space and Astronomy Agora |
| Fine Grinding
Forum List | Follow Ups | Post Message | Back to Thread Topics Posted by Willie Orr on July 9, 2002 14:03:01 UTC |
I just moved from 320 to 12 micron and after a few wets (tot) I found many scratches. Most are light but one appears to be a little deep. The tool appears to be clean with no sharp edges. Could this be from too little water? I premixed the 12 micron. I thought I would try again with 12 mircon....or should I go back to 320? Thoughts? |
|
| Additional Information |
|---|
 |
| About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy |
|
Unless otherwise specified, web site content Copyright 1994-2025 John Huggins All Rights Reserved Forum posts are Copyright their authors as specified in the heading above the post. "dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET" are trademarks of John Huggins |