Back to Home

ATM Forum Message

Forums: Atm · Astrophotography · Blackholes · Blackholes2 · CCD · Celestron · Domes · Education
Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem
RSS Button

Home | Discussion Forums | Amateur Telescope Making | Post
Login

Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place...
The Space and Astronomy Agora
Geometry Of Evacuated Membranes

Forum List | Follow Ups | Post Message | Back to Thread Topics
Posted by Matthew Brackman on October 27, 2000 17:13:59 UTC

Hi Folks -

Just found this site and W.O.W. nice to see some folks thinking about the same things I am.

Here's an idea I had but don't know enough math to figure it out. Maybe someone else does:

If one end of a large diameter, sealed tube or short height, (think snare drum) is covered with a thin sheet of mylar and then evacuated, what is the resulting geometry of the mylar surface? Spheroid or parabolic? What if the mylar is on an elastic (rubber/polymer) substrate? What if it is evacated AND spun? What if the center point of the sheet is secured by a "wire" to the opposing tube end, THEN spun and not evacuated?

Since the goal is to find a natural process to take the work out of grind, casting etc...how else can we let nautral processes do the work?

Any thoughts would be welcomed.

Follow Ups:

Login to Post
Additional Information
Google
 
Web www.astronomy.net
DayNightLine
About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy
Unless otherwise specified, web site content Copyright 1994-2020 John Huggins All Rights Reserved
Forum posts are Copyright their authors as specified in the heading above the post.
"dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET"
are trademarks of John Huggins