RE: Does Anybody Realy Want A Large Blank? - an Astronomy Net ATM Forum Message

ATM Forum Message
Forums:	Atm · Astrophotography · Blackholes · Blackholes2 · CCD · Celestron · Domes · Education Eyepieces · Meade · Misc. · God and Science · SETI · Software · UFO · XEphem


Home \| Discussion Forums \| Amateur Telescope Making \| Post	Login

Be the first pioneers to continue the Astronomy Discussions at our new Astronomy meeting place...
The Space and Astronomy Agora

RE: Does Anybody Realy Want A Large Blank?

Forum List | Follow Ups | Post Message | Back to Thread Topics | In Response To
Posted by Stephen Campbell on May 10, 2000 08:51:56 UTC

Are these blanks casted as one piece,or are they
fused ribs on a face and/ or back plate,and what is the pattern? hexagonal,triangular,sounds like
one piece,you mentioned a water knife,im assuming
this is used to create the rib like pattern in back of the face plate.
I would be interested,like any atm this all depends on the cost,most atms as you probably
know ,cannot afford to spend thousands on a blank
in this range of diameters.give me a quote on a 20"X3"thick.stevec@ultrasw.com

Follow Ups:

RE: RE: Does anybody realy want a large blank? - Maybe less than you expect. - May 10, 2000 - 17:42 UTC

Additional Information

About Astronomy Net | Advertise on Astronomy Net | Contact & Comments | Privacy Policy

Unless otherwise specified, web site content Copyright 1994-2024 John Huggins All Rights Reserved
Forum posts are Copyright their authors as specified in the heading above the post.
"dbHTML," "AstroGuide," "ASTRONOMY.NET" & "VA.NET"
are trademarks of John Huggins